Fabrication and experimental study of transformer 400 V with a simple rectifier circuit design

Abstrak

The demand for increased voltage in renewable energy sources is relatively high. This study examines the rapid development of technology considering the use of voltage-increasing transformers. Voltage regulator circuits are generally used to stabilize the output voltage of the rectifier according to the amount of input from the transformer. However, components for high-voltage stabilizer circuits are rare, which becomes an obstacle to the stabilization of the rectifier output. This study aimed to determine the performance of the designed rectifier circuit against a non-center tap step-up direct current (DC) 400 V transformer and compare the measurement results to manual calculations. The research method is a direct comparison between the input and output voltage values of the transformer after going through a rectifier circuit. This experiment was conducted using the repeatability method three to five times for each voltage variation on the transformer. The voltage variations successfully created are 0 to 50, 0 to 100, 0 to 200, and 0 to 400 V. The output test results from the DC transformer and rectifier circuit show linear results and an increase in peak-to-peak voltage data between the transformer and rectifier outputs by 3.8%.